BX645A - follow up (Techniek Radio/TV)

door Pandu Rajan @, 22.09.2024, 07:23 (23 dagen geleden) @ Sieme

Dear mr Sieme
Thank you very much for your reply. I had loosened the disc screw mounted on the band switch and May be this was causing the motor to run past the open sk7 zone as there was no load. I opened the connection of sk7 and checked the switch and it is working correctly. Resoldered the connection of sk7 and readjusted the three discs. Now the motorised band switch is working correctly on kg2b to kg2d and kg3. On kg2a it is not working correctly as the motor does not stop. On MW the supply is tripping which I think there is some short which I have to check
Regards
PRajan


Berichten in deze thread:

 RSS Feed van deze thread

powered by my little forum